ISSA number

[News]

HOMENewsKnowledge of CleanlinessHow Often Should the Scrubber Consumables be Replaced? What Should be Paid Attention to in use?

How Often Should the Scrubber Consumables be Replaced? What Should be Paid Attention to in use?

2023-07-19 05:07:49

You must have any questions in this regard, Chancee to help you answer the questions today , so that you can grasp the service life of the consumables and precautions quickly.

 

1.Brush plate

 

Replacement cycle: generally used for about 3 months.

 

Uneven ground or long washing time can accelerate wear and tear; when the length of the bristles is less than 1.5cm, it needs to be replaced.

 

Note: It is strictly prohibit to idle the brush plate ; When replacing the brush plate, ensure that the brush plate is installed in place to avoid cause the brush plate to fall off repeatedly and cause wear and tear of the brush plate buckle.

 

 

2.Scouring pad

 

Replacement cycle: generally used for about 1-2 weeks.

 

It is widely used for cleaning, waxing, and polishing floors and tiles,etc.; When the thickness is lower than the height of the needle plate, it needs to be replaced.

 

Note: It needs to be used with a needle plate; check the wear regularly and replace it if necessary to avoid damaging the paint or wax layer on the floor and destroying the surface of the floor.

 

 

 

3.Needle plate

 

Replacement cycle: generally used for about 3-6 months.

 

Don’t stick the scouring pads too much, otherwise it will accelerate the wear and tear of the needle plate, and it needs to replace the pads when It can’t stick scouring pads.

 

Note: It must be used with a scouring pad and cannot be used alone; It is strictly prohibited to idle the needle plate; When replacing the needle plate, ensure that the brush plate is installed in place to avoid repeated detachment of the brush plate and wear of the needle plate buckle.

 

 

 

4.Water absorbent strip

 

Replacement cycle: generally used for about 3-6 months.

 

It is too close to the ground or uneven ground can accelerate wear and tear; When you visually see that the water absorbent strips are worn or deteriorated, deformed as well as not able to stick to the ground even when adjusting the gimbals, then they need to be replaced.

 

Note: When there are acidic, alkaline, and oily substances in the use environment, choosing to match them with blue anti-corrosion water absorbent strips; The water absorbent strips should not be too close to the ground in use, which will cause the water absorbent strips to resonate and accelerate the wear and tear of the water absorbent strips.

 

 

5.Brush plate buckle

 

Replacement cycle: generally used for about 3 months.

 

It is determined by the frequency of disassembling and assembling the brush plate ; when the middle part is worn and the brush plate cannot be clamped, it needs to be replaced.

 

Note: It is strictly prohibited to idle the needle plate or brush plate; Do not install or dismantle violently.When replacing the brush plate, ensure that the brush plate is installed in place to avoid repeated detachment of the brush plate and wear of the brush plate buckle.

 

 

 

 

kindly reminder: There is no fixed parameter for the actual replacement cycle, which depends on the actual frequency of use and the environment.

 

Contact Us